Services

Clean & Checks

During a routine inspection, the service technician will perform the following general maintenance measures. The technician may perform other checks too, depending on the type of furnace.

• Clean and check ignition system and burner assembly.

• Check flue pipes, draft diverters, heat exchanger, and chimney.
  

• Remove burners, to clean burners and heat exchanger, if necessary.

• Check electrical wiring connections.
  

• Check and clean circulating fan and lubricate if necessary.

• For belt driven fans, check tension, wear and alignment.
  

• Check supply and return air ducts for leaks, water stains and rust.
  

• Check and maintain filters.
  

• Perform an operational check of furnace and safety controls.
  

• Test for carbon monoxide in the flue gas and surrounding area of furnace.
  

• Check for gas leaks.
  

• Clean, check, and adjust pilot and gas pressure if necessary.

For High Efficiency Furnaces, the technician will also check…

• Check for water leaks (condensation from combustion).

• Check flue pipes and connections.

• Check for condensation on metal pipes and parts.

• Check for a clean condensate line.

• Check operation and condition of draft fan.

Repairs

• Systematic analysis of the failure and symptoms.

• Normal operating parameters are compared to the observed conditions.

• All inoperative or faulty components are proven bad by appropriate test.

• You will be given all replaced components for your examination.

• Professional corrective actions.

• Our policy is to restore the Original Equipment Manufacturer components and configuration, or better.

• Although necessary in some emergencies, we will not make "Bandage" or "Make Do" repairs.

• All repairs are double checked to confirm proper operation.

• You will receive a complete verbal explanation of the failure, cause, and corrective actions.
  

Installation Service Includes:

• Equipment delivery and setup.

We transport equipment to your location and perform all necessary setup.

•  Refrigerant line set piping.

To whatever length permitted by the connected components, line sets are installed neatly and professionally.  Our pipe fitting and configurations are by proper refrigerant line standards, with special care to avoid installation contamination to the system.  All line sets are securely anchored and tested to insure their integrity for years to come. 

• Water and drain line piping.

As required by much HVAC/R equipment, we will install all required plumbing in a similar manner as our refrigerant piping practices. 

• Electrical circuit wiring.

Provide the necessary sub-circuits to most HVAC/R equipment.  All required power and control circuits are installed to manufacturer specifications.  

• Sheet metal fabrication.

Although limited, we can provide most sheet metal fabrication and installation associated with HVAC/R installations.

• Venting products of combustion.

Proper venting associated with products of combustion.